NEW! Make sure ignition is turned off for at least 10 minutes before installing.
Locate accelerator pedal electrical connector and disconnect.
Plug corresponding connectors into respective plugs.
Tie wrap the cables out of the way.
Determine a good location for TSC Controller placement where it will be easily accessible.
Mount using the supplied 3M Velcro 2 sided tape
Turn on ignition the Power Level LEDs will be in pre calibration mode (chasing) VERY IMPORTANT PART READ CAREFULLY AND UNDERSTAND BEFORE PROCEEDING PUSH AND HOLD BOTH THE UP AND DOWN BUTTONS BEFORE PRESSING ON THE ACCELERATOR PEDAL THEN WHILE BUTTONS ARE PRESSED PUSH THE ACCELERATOR TO THE FLOOR RELEASE THE 2 BUTTONS WHILE THE ACCELERATOR IS STILL TO THE FLOOR AFTER YOU RELEASE THE BUTTONS YOU CAN REMOVE YOUR FOOT FROM THE PEDAL
Only the first LED should be illuminated at this time.
